![]() It has been updated in the runing-config after the copy. Also, the fa0/0 interface is different in the initial running-config than on the tftp server. ![]() Note that s0/0/0 has an ip address configured in the running-config but not on the tftp server but still exists in the running-config after the copy command was issued. The example on the slide shows how when performing a copy tftp running-config or a copy startup-config running-config the files are merged, not replaced. Parameters for the respective ftp and rcp qualifiers differ from the tftp parameters.Ĭisco CCNA Cisco IOS copy Command Example Note: In place of tftp, ftp or rcp can be utilized. To erase the startup-config use the erase startup-config or write erase commands. Note the copy startup running and copy tftp running-config commands merge the source file with the running-config it does not perform a complete replacement like the other commands. The above commands are just some of the commands to copy router configuration files from one place to another. ![]() You can also use ftp versus tftp using the following command: The full syntax of the command is as follows: Make sure you have a copy of the image file somewhere on your TFTP server in case restore becomes necessary. If you don’t have enough room in flash memory to store both copies, or if the flash memory is new and no file has been written to flash memory before, the router will ask to erase the contents of flash memory before writing the new file into flash memory. ![]() You will still need to specify this when prompted during the download. bin, and some operating systems like Windows will truncate or hide the file extension. ![]() This command requires the IP address of the TFTP host and the name of the file you want to download.īut before you begin, make sure that the file you want to place in flash memory is in the default TFTP directory on your host since when you issue the command, TFTP won’t not ask you where the file is. No worries-you just download the file from a TFTP host to flash memory by using the “ copy tftp flash” command. What happens if you need to restore the Cisco IOS to flash memory to replace an original file that has been damaged, or if you want to upgrade the IOS? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |